Nair Sensitive Strip Free Wax 400g
The secret to this wax’s gentle hair removing power is a combination of two soothing botanical extracts – Argan Oil and Orange Blossom Extract. The new Nair Sensitive Strip Free Wax contains Zinc Oxide which allows the wax to adhere to the hair and less to the skin, helping to minimise the pain of waxing.
This strip free peel off wax can be used on hair as short as 2mm, which means no waiting for unsightly re-growth, and gives super smooth, effective results.
For a safe and effective hair removal treatment using Nair Strip Free Peel Off Wax follow the steps EXACTLY.
STEP 1 PATCH TEST
Before each use always do a patch test. Apply a test sample to a small area where product will be used following the basic instructions. Wait 24 hours before applying product to a larger area. A slight reddening of the skin is normal for several hours after removal of hair. In cases of extreme skin reactions, discontinue use immediately and do not proceed with full treatment. If skin appears normal, proceed.
STEP 2 CLEANSE THE SKIN
Wash area to be waxed with mild soap and water. Dry thoroughly.
STEP 3 HEAT THE WAX
CAUTION When heating, this jar should NOT be put in the middle/centre of the microwave oven. Put the jar to one side and follow the enclosed heating instructions carefully.
Take extreme caution not to overheat.
Never heat wax tub in the carton, with the wooden spatula, or with any other object in it.
Do not use a tub with any defects or if deformed while heating.
Do not leave the microwave unattended during heating.
Keep out of reach of children.
- Place the uncovered tub in the microwave oven, off centre on a microwave plate.
- Always use your microwave on the ‘high’ setting if you have the choice. Never ‘defrost’ or ‘cook’.
- Check the table below for the appropriate heating time and start your microwave.
AMOUNT OF WAX MAXIMUM TIME (900 WATT MICROWAVE)
FULL TUB 1 MINUTE 45 SECONDS (105 SECONDS)
HALF TUB 2 MINUTES (120 SECONDS)
WARNING: Never allow wax to boil. Overheated wax can cause serious burns. The heating time should be adjusted according to the amount of wax in the tub and the power of your microwave. The recommended heating times in the table above are supplied as a guide only for microwaves with a power of 900 watts. The heating time must be very exact. If your microwave oven does not have a digital time setting function (with minutes and seconds indicated exactly), control the heating time with the aid of a watch with a seconds timer. To avoid risk of burning, never exceed these heating times.
STEP 4 LEAVE WAX TO STAND
Leave the tub to stand in the microwave (switched off) for 3 minutes straight after heating to allow a better diffusion of heat through the wax.
STEP 5 STIR THE WAX
- After letting the tub stand in the microwave, take it out of the microwave while keeping it level with the help of the two handles. It is recommended to use a towel to remove the tub from the microwave.
- Dip the spatula very gently into the tub, right to the bottom (there shouId not be any resistance) and gently stir the wax from bottom to top until all of the wax contained in the tub reaches a uniform consistency and temperature.
NOTE: After heating, the wax could have two different parts:
• A liquid part
• A solid mass
Mixing these two parts will create the ideal consistency of smooth creamy honey. If the wax is not sufficiently softened, and therefore is difficult to stir or spread in thin layers, put it back into the microwave to heat for 10 seconds at a time (never more) until the ideal consistency is achieved.
WARNINGS
If the wax is liquid or bubbles appear, it has been overheated. In this case, let it cool before handling it. The wax will need to be left for at least 15 minutes. If the wax is still solid at the top, there is a risk that it could be boiling hot underneath and could spit out wax when the spatula is dipped in. In this case, leave to cool for at least 5 minutes until the solid part has softened before putting in the spatula.
STEP 6 CHECK THE TEMPERATURE
Be extremely careful: to avoid risk of burning, always check the temperature of the wax with a small amount on the inside of the wrist before proceeding with the full hair removal treatment. If the wax is too hot, leave to cool.
STEP 7 APPLY THE WAX & REMOVE HAIR
NOTE:
- Wax must only be applied to clean, dry, non-irritated skin without any trace of oil, cream, lotion, moisturiser or perspiration.
- Do not use to remove hair for 2 hours after a shower or bath, when the skin is still too hot or too moist.
- Do not use 24 hours before sunbathing or 24 hours after sunbathing.
- Apply talc before applying each strip of wax.
Before removing hair, place the following items within reach:
- This instruction leaflet
- The tub of softened, well-stirred wax
- The wooden spatula
- Aftercare wipes
- Talc
It is advisable to protect the area where you will be doing the hair removal treatment (under the tub in particular) with a newspaper or paper towel for example.
APPLYING THE WAX
NOTE: NO CLOTH STRIPS ARE NEEDED. THE WAX ITSELF BECOMES THE STRIP TO BE REMOVED.
- Dip the spatula into the tub of wax and take a large knob of wax with the end of the spatula while rotating the spatula to prevent the wax from running or dripping.
- Place the knob of wax at the top of the area to be treated and using the spatula, spread immediately in the direction of hair growth, a layer of wax thin and even in the centre (1 to 2mm thick) and thicker along the edges. The strip should form a slight curl around the edges which will make its removal easier.
- At the lower end of the wax, leave a small amount not pressed down, so that you have a free end to make it easier to remove.
- Allow the strip of wax to set for about 20 seconds; the wax has set once it no longer sticks to the touch and the edge can be lifted without difficulty (i.e. it no longer sticks to the skin). Do not leave the wax on the skin for more than one minute.
REMOVAL OF THE STRIP WAX
- Stretch the skin with one hand below the wax and with the other hand, lift the lower edge of the wax with the fingertips.
- Pull the strip back in a quick movement in the opposite direction to application, and as close to the treated skin as possible.
o Do not reuse the wax
o Do not re-wax area if skin is red or irritated
ADVICE FOR SPECIFIC AREAS
It is recommended that talc be applied to areas before applying wax. Ensure that the area is completely dry. If the hair is too long, cut it down to approximately 6mm. It is important the skin is pulled taut during application.
LEGS
Wax should be applied from the top of the lower leg towards the ankle and removed in the opposite direction (see pictures under the heading ‘Applying the Wax’).
UNDERARMS
Underarm hair removal should be carried out in two steps, as the hair grows in two different directions (at the top towards the top, and at the bottom towards the bottom). Place your hand behind your neck to stretch the skin.
- On the upper part of the underarm: Apply the wax towards the elbow.
- Remove it in the opposite direction, pulling back quickly, as close to the skin as possible.
- On the lower part of the underarm: Apply the wax towards the bottom.
- Remove it in the opposite direction, pulling back quickly, as close to the skin as possible.
BIKINI
1. Spread the wax in the direction of hair growth (usually towards the insides of the thighs).
2. Remove in the opposite direction, pulling back quickly, as close to the skin as possible.
UPPER LIP
Treat each side of your upper lip separately. Spread the wax in the direction of the hair growth. Hold the cheek skin taut with the free hand and quickly pull the strip off in the opposite direction. Repeat for the other side of the upper lip.
CHIN, CHEEKS, CENTRE BROWS
Spread the wax in the direction of hair growth. For chin, hold skin on neck taut before pulling the strip in the opposite direction as shown. Spread wax from cheekbone down. Hold the skin taut on neck or side of face and remove the strip in opposite direction. For centre brows use as shown.
STEP 8 AFTER HAIR REMOVAL
Complete the treatment by cleaning the skin with either the aftercare wipes supplied or baby oil. Never use water or other products (e.g. Alcohol or Acetone) to remove any wax residue.
• To remove large areas of residue wait until these are completely dry and remove with fingers.
• To remove fine residue apply talc to the treated areas to make the residue easier to see, then rub with the aftercare wipe supplied until it disappears.
o It is normal for a slight redness to appear after removing hair; this will disappear naturally after a few hours. You can apply an ice cube or a cold compress for a few moments.
o Avoid any prolonged exposure to the sun for 24 hours after removing hair, in order to avoid provoking unwanted skin reactions.
o Wait 24 hours before using deodorant, perfume or astringent lotions on the waxed area.
CAUTION
IF THERE IS WAX LEFT OVER FOR ANOTHER TREATMENT
• Do not leave the spatula in the tub; remove as much wax as possible from the spatula by scraping it against the inside of the tub.
• Adjust the heating time according to the amount of wax that remains.
• Store the tub in the carton with this leaflet for the next treatment.
We advise that you wait 72 hours between applications.
No, as a general rule, waxing the legs is relatively easy and straight forward. You should take greater care in testing when you need to wax your underarms, face and bikini line, as the skin is more sensitive.
Nair Bikini and Underarm Roll On WaxMost Nair products can be used for a period of 3 years from the date of manufacture printed on the pack, unless otherwise indicated on the pack. It is important to follow storage conditions.
Yes, you can use baby oil to remove any remaining wax. If using Nair™ Roll-On Facial Wax use warm water and a clean cloth to remove unwanted wax residue.
Results can last for several weeks. If hair re-grows within a day or two you probably need to practice your technique as you may be snapping off the hair rather than removing from the root. See pack for detailed instructions.
The general guideline for Nair™ Wax products is 1-week's hair growth; however, for Salon Divine™ wax products the hair only has to be 2mm. Follow product use and warning instructions for each specific product.
Nair Hair Removers exfoliate skin in addition to removing hair, so using it before a self tanning product will help you to have a more even tan. Wait 24 hours between using Nair products and tanning.
No. It is advised that you wait at least 24 hours before heading out into the sun, please always use a sunscreen.
As a precaution, we advise not to use any Nair products on skin which has been shaved in the last 72 hours.
If you have no adverse or allergic reaction when testing the product as per the directions for use and precautions, there is no reason why you cannot use it. Conducting a small patch test will help.
Yes, you should. The skin is very sensitive and can frequently change its composition with changes in your hormone levels. Since your skin is constantly in a state of change, we advise that it is necessary (not just desirable) to do a patch test each time to avoid any adverse reactions to the ingredients in our products. This is despite our rigorous dermatological testing process – as everyone’s skin is different, at different points.
CAUTION
Patch test before each use by applying the product to a small part al the area where hair is to be removed. Follow directions and wait 24 hours. If skin appears normal, proceed. Never reapply wax on same area within a 24 hour period. As with any wax treatment, some discomfort may be experienced. Your skin may turn slightly red for a short time after treatment. This is normal and will soon disappear. If the skin to be treated is not held taut, and the wax is not zipped or pulled back very fast and close to the skin, then a pinching effect may be felt, a wax residue will remain on the skin or worse, skin could be removed resulting in injury.
Read the instructions carefully, proceed at all times with caution. Heat only in a microwave. Do not heat in saucepan of hot water. Do not use in conventional or toaster oven. Microwaves vary in power output so heating guidelines are an indication only. Take extreme caution when warming the wax not to overheat Never leave the heating wax unattended. Remember the tub containing the wax will also become hot therefore we recommend placing the tub on a microwaveable plate. Remember to use caution when handling, testing or applying the wax. If it is too hot it could cause you serious injury.
WARNINGS
Do not use product in the area of the eye. Wax should not be used by people suffering from diabetes or circulatory problems or on areas with varicose veins, moles and warts. Do not wax inside nose or ears, on nipples, perianal, vaginal/genital areas or eyelashes. Do not use on irritated, inflamed or broken skin. Not suitable for people with extra sensitive or problem skin. Not recommended for the elderly or people with loose skin. Do not apply wax over sunburned, chapped, broken or sore skin, cuts, weak scars or eczema. Do not use immediately after a bath. Do not sunbathe 24 hours before waxing or 24 hours after waxing. Do not ingest. Failure to follow these warnings may result in severe skin irritation, skin removal, burns or other injury. Keep out of reach of children.
Appropriate hair length: This wax is intended for use on hair as short as 2mm and can be used on hair with more than 1 week of growth.
Skin preparation: Skin should be clean and dry, free from oils, creams, lotions, moisturisers and perspiration. Wash skin with soap and water, and dry thoroughly before waxing. We recommend that you lightly dust the area to be waxed with talc, particularly when the climate is hot and humid.
WARNING: Any overheated wax can cause serious burns. For a safe and effective hair removal experience follow the steps exactly.
